Posted on

starburst bowl weed

You are almost done, and all that’s left is sealing off the long chamber in your weed pipe so that you can draw from the device. Though some might prefer to leave it alone and use the addition as a carb, the easiest way is to seal it off with one final unaltered Starburst candy.

Shape and install a fine mesh screen with pressure and your homemade weed pipe is ready to go.
Once all the pieces have been pierced, apply a small amount of pressure to fuse them all together. Starburst candies are quite sticky, so you shouldn’t need water or any other messy materials to make that happen. When they stick together, it should be relatively easy to pull the entire row of candy off the screwdriver in one piece.

Candy flavored marijuana strains
The next step is making an elbow joint, that will connect the weed pipe base to the bowl. To do this, take one piece of Starburst and piece it just like you did with the other, but then remove it and poke an additional hole in one of the smaller edges that meets the one in the middle, try not to go past it.
How to make a homemade pipe with Starburst
Just when you think you’ve seen everything, along comes the Starburst weed pipe, a delicious addition to any DIY project collection. If you ever find yourself without a bong, pipe or rolling papers, then this handy cannabis enthusiast hack might come in handy. Even if you don’t, the process of creating this masterpiece weed pipe is so much fun that you will have the urge to show your friends again and again. The best part is, these lovable candies are so full of flavor that they can improve the taste of any mediocre product.
Next, take a screwdriver and slowly feed each piece onto the metal rod just like you would prepare a skewer for dinner. Technically, you can make your homemade weed pipe any size that you’d like, but experience shows that 7 pieces make a good base for your first chamber.

The next step is the candy bowl, which consists of two pieces of Starburst that are fused together. Use the screwdriver to poke a hole through the center, then tilt it on an angle to gently shape the top opening into the perfect bowl shape.

Just when you think you’ve seen everything, along comes the Starburst weed pipe, a delicious addition to any DIY project collection.