Posted on

pruning weed plants

Pruning weed plants
If you take one of the branches on your plant and bend it slightly, it should form a sort of callus which will double the strength of the branch. The cells in your plant will make their way to the injury and they’ll strengthen the branch, allowing it to put up with much more weight. As well as not growing any more, the end bud will have heavier buds. All you have to do is bend the branch slightly, making sure not to go too far; if you actually break it then that’s that. If done correctly, you should end up with thick balls of buds and compact, strong plants. You’ll be able to grow less plants in your grow tent but with a higher production rate.
You can prune to change your plants’ shape, but never prune at the top to allow more light to reach the bottom; the top is always more productive than the bottom even if you want it to get more light. The logical thing to do would be to prune the bottom so that the top can produce even more.
None of the leaves are disposable, even the smallest ones. Every single one is needed so that they grow properly. If you want to test this out yourself, trim one of the big leaves while your plant is still in the growth phase. You’ll notice how the branch carrying that leaf will stop growing, and branches with all of their leaves will continue growing without any issues. The same thing will happen to the buds; if you remove a leaf so that the lower buds can get more light, the higher buds will end up dwarfed and a lot less potent, when they would have been much bigger than the lower ones to begin with.
To do this, you need to make sure that the part of the plant that you want to use as a cutting is above where you’re cutting, and that there are a few small branches on it. You also need to leave a knot above the spot where you cut so that when you plant it again you can plant it deep up to the knot, because that’s where the roots will be coming out of. You’ll need to cut it just like the picture, take off the little branch from the knot where we’ll be burying our plant, make sure that you cut it at a 45º angle, and then you should put it straight into some rock wool, jiffy, or whatever you prefer. After a few days, following the right steps (go check out the article we’ve done specifically on rooting clones), your plant should have some roots.
Another thing that you mustn’t do is prune your plants while they’re flowering. Plants need a few days to recover from prune-induced stress, and it takes a while to decide where the new branch or central stem is going to grow from. You’ll need to prune at least 15 days before you switch your plants to the growing period or before summer begins for outdoor crops. You need to prune during the growth period every time, or else the start of the flowering period may be compromised.
Some strains absolutely hate it when you prune them to increase their number of branches, so in these strains what you’ll want to do is increase the amount of production on the central stem. These strains tend to be indicas. The one that’s easiest to recognize with this kind of shape is Critical+. These plants center most of their production on the main “eye” of the plant, the central calyx, so to get the most out of these plants you’ll need to place a whole lot together and prune/trim the lower branches. This way you’ll be able to grow up to 16 plants per square meter without them getting tangled. The idea is to prune those branches that come out over the flowerpot, leaving just the main stem and 4 to 6 branches around the bottom. To make sure that it doesn’t end up doubling over with the weight you should wire or string it, and you’ll have 16 extremely productive plants where before you could only fit 9.
We’re going to talk about a few different pruning situations, along with a picture and an explanation so that you know where you have to cut depending on the result you want, because not all pruning is done the same or for the same reason, so each type has a different effect on your plants.
Inicio » Tips » When and How to Prune Marijuana Plants
If you’re looking to learn how to do other kinds of pruning, leave a comment and we’ll do our best to add it on to the article.
Comprehensive article on when and how to prune marijuana plants depending on the effect you want the pruning to have. Read on to find out more.
Pruning weed plants
If possible, try to use a separate pair, and not the same sharp scissors you plan to use for trimming buds. Some branches are tough enough to destroy a pair of nice scissors in a single harvest. You want sharp scissors for trimming your buds; it will save you so much time!
If you haven’t yet, it’s time to securely dispose of the remainder of the plant!
Be warned, these are all obscenely expensive! (Seriously, stick to Fiskars!)

  • The untrimmed buds took 0.5 to 3 days longer to dry. The leafier the plant, the longer it added to the dry time.
  • The biggest difference is I noticed the “dry trim” buds seem noticeably more dense/uniform.
  • The dry vs wet trim buds smell a bit differently, but all smell good. Neither seems particularly stronger or better as far as smell.
  • I noticed that the “dry trim” buds often seem more brown as if they’ve been curing for months. The effect was most pronounced on the leafiest plants, which may have taken a little too long to dry.
  • As far as comparing taste/smoothness/potency. In blind tests with cannabis enthusiasts, I’ve gotten mixed results. Some people prefer the smell or smoothness of the buds one way, while others like the exact opposite. It doesn’t seem to follow any particular pattern that I can tell. I truly think it’s a matter of personal preference, and also varies from strain to strain.

Trim before or after drying? (“Wet Trim” vs “Dry Trim”)
Although these cannabis buds are beautiful and the sugar leaves are absolutely covered in trichomes (so you know they have significant amounts of THC), the buds may possibly be slightly more “harsh” than if all the sugar leaves had been trimmed away.
2.) Wash your hands and put on a pair of gloves
I prefer latex gloves as they’re sturdy and it feels easier for me to change into a new pair. But any gloves you like will do the trick!
Fiskars shears are very sharp and one of the most popular types of scissors for trimming buds by hand! These are what I use to trim my buds!
Learn how to trim your buds so they look like the ones at a dispensary!