“IT’S F*CKING WILD” –NOWTHIS
A Universal Gravity Water-Pipe
Shipping Date: June 30th, 2020
Back Order Open now
Do you like sharing germs? oh. No? Perfect
Groundbreaking fluid dynamics
The Infinity Waterfall was invented by a few entrepreneurs from New Jersey and New York who enjoyed the huge hits that waterfalls and gravity pipes provided but hated the mess. We wanted to take the concept of waterfalls to the next level. We arrived at an hourglass design so you don’t have to fuss with draining and refilling all the time. Also, no one likes the taste of burnt plastic…
Never touch your lips on dirty glass again.
THE WORLDS FIRST INVERTIBLE WATER PIPE
Waterfall bongs can be made from any number of plastic bottles, be it a soda bottle, water bottle or even a Gatorade bottle. The only thing that you need to add to the bottle is something to act as a bowl, stocking pipe or cone.
- A bong smoking bowl
- Duct tape or electrical tape
- A bottle with a cap
- A sharp and pointy implement or a drill
- A lighter, or a hemp wick
Before releasing the the water, attach the cap and light your stash. You will want to make sure that you have set light to your stash before letting the water out. This way you will be able to ensure that you can draw in as much smoke into the bottle as possible.
Giving direction on how to attach the bowl to the cap can be rather difficult for us to do as this will be highly dependent on the type of bowl you are using. Ultimately, what you need to do, is make sure that the bowl is tightly affixed to the cap, while sticking through it. The opening of the bowl needs to be facing up, with the base of the bowl sitting below the cap. When the cap is put back on, you want the smoke coming out of the base of the bowl to be trapped inside the bottle.
Have you ever wondered how to make a waterfall bong? Or are you looking for a strong hit that wastes little of the precious smoke? Then this is the article for you.
Before filling your bottle with water, we would suggest packing your bowl first. This way you can avoid getting your stash wet, and allows you to seal the hole(s) with your fingers.
In this article we will be going over how a waterfall bong works, and how to make one of your very own, with our step by step guide.
Using the sharp pointy implement you need to pierce the bottle near its base. The lower the hole will be, the more water will drain out and the more smoke that can be pulled into the bottle.
If you are going to be sealing the hole(s) with the tape, do so before filling the bottle with water. Do not fill the bottle all the way to the top, it is better to leave a small air pocket.
How to Make Waterfall Bongs Have you ever wondered how to make a waterfall bong? Or are you looking for a strong hit that wastes little of the precious smoke? Then this is the article for you.