Posted on

autoflower lighting

Autoflower lighting

However, it’s important to note that many growers grow plants successfully even after providing 24 hours of light. They believe that the more light the plants get, the better the results. But, while it might work, it’s surely not as productive as the other light cycle described below.

The 18/6 light cycle is perhaps the most common cycle used by most growers. What makes this schedule perfect is that while it provides more than 14 hours of light necessary for the plant to perform to its fullest potential, it also offers six hours of rest.
And, it goes without saying that you save extra money if you switch off the lights. A few hours every day may not seem like a lot, but it does add up in the long run.

Photoperiod plants start flowering only when the period of darkness increases, but autoflowers don’t rely on any such signal to do their job. They only produce buds with time, rather than following any particular light/dark cycle.
With even 6 hours of darkness or resting period, the plant has enough time to recover and grow normally. It’s perfect for beginners that are intimidated by autoflowers. Autoflowers are programmed to grow as quickly as possible and they begin to flourish right from the get-go.
Try growing two plants under different light cycles. While it’s possible for the plant receiving 24 hours to grow vigorously at the beginning, the growth slows down later. With absolutely no period of rest for the plant, the productivity drops down a bit. The difference will also be evident in the yields as plants without rest don’t generate too many buds.
Last but not least, you save money even if you reduce only 6 hours of light per day. It equates to a reduction of 180 hours of light per month! Plants in the 18/6 cycle grow extremely well, so you’re cutting down the electricity by 180 hours in a month. And now that you look at it that way, the 18/6 cycle certainly seems like a better option, eh?
What if you can’t make up mind between 24/0 and 18/6 cycles? You want the plants to grow as much as they can. You’re convinced that the 24/0 is the way to go, but a nagging doubt makes you wonder if it’s overkill. It also logical to think that the plants need some shut eye for at least 6 hours to continue growing the next day.

On the other hand, 18/6 seems too less for you. You’ve got the best equipment and are pretty confident that the lights, fans, and other equipment will sail through without any hiccups. So, what do you do?

In the cannabis kingdom, the Ruderalis has the answer to many problems. It’s perhaps the next best thing discovered since flatbread for several reasons. F

Autoflower lighting

After vegging under metal halide, growers will often switch to high-pressure sodium lights for flowering. In terms of electricity used per unit of energy for the cannabis plant, the MH/HPS combo is the best option. However, neither of these lights come cheap, and while they may be efficient in relative terms, they still use a great deal of power in the process, and you’ll see it on your electric bill.

If you want to save on start-up costs: Four to six CFL bulbs are your cheapest option, but you’ll pay for it in power consumption later.
CFLs are those twisty bulbs you probably already have in your home. They can be found in any hardware store. Their ubiquity makes them an ideal solution for a discreet grower who doesn’t want cultivation supplies on his or her credit card statement. Their only downside is that while each bulb has relatively low power consumption, you’ll need several bulbs to provide enough light to grow ganja. Power consumption might reach over 400 watts to generate enough illumination.

T5s are what you probably picture in your head when you hear the word fluorescent. These long tubes of electrically charged gas have been around since the 1930s. Cannabis responds better to the T5 light spectrum than CFL’s, and they’re powerful enough to grow a plant from seedling to harvest. They’re a bit more conspicuous than CFLs, but it’s not unheard of for people to have homes lit by T5 lights, especially in East Asia.
HID bulbs blast out massive amounts of light, and you’ll notice it in your plant’s growth if you decide to use them. They utilize the perfect spectrum for cannabis cultivation, but they also generate large amounts of heat and use a great deal more electricity than other options.
If you want to save on electricity: A 100-watt cob light will use the same amount of energy as a single old-school incandescent bulb would have. If you don’t want to see your energy costs increase, COBs are your best option.
There’s something genuinely satisfying about planting a seed in the ground and watching a cannabis plant seemingly appear out of nowhere, fed by the sun. Unfortunately, prohibition prevents many growers from doing just that. They have to take their growing indoors, away from the light source these plants were designed to use. Indoors growers have to pay for every lumen of light, and replicating the sun doesn’t come cheap. Thankfully, lighting solutions for cannabis growing have come a long way in the past ten years. Before, even the smallest growing operation would use as much power as an air conditioner or over-powered gaming PC, whereas today it’s possible to grow weed with bulbs that use less energy than the lights in your kitchen.
LEDs are the perfect low power solution for growers with smaller tents and those growing with discretion in mind. Their low power usage means you’ll barely see an uptick on your electricity bill, at least if you’re only using one or two lights.

Rarely used for the length of a full grow, metal halide lights provide the ideal blue spectrum for vegging cannabis plants, but many growers switch to HPS come flowering.

There’s something genuinely satisfying about planting a seed in the ground and watching a cannabis plant seemingly appear out of nowhere, fed by the sun. Unfort